ESP32 Forum

Raphelchen wrote: ↑

Thu Jul 20, 2023 9:49 am

Hi,
i have two timers for a esp32-s3 on esp-idf 5.0.2
I init the timers with:

Code: Select all

gptimer_config_t timer_config = {
    .clk_src = GPTIMER_CLK_SRC_DEFAULT,
    .direction = GPTIMER_COUNT_UP,
    .resolution_hz = 1000000, // 1us
  };
  
  //Setup Callback
  gptimer_event_callbacks_t cbs = {
    .on_alarm = timer_interrupt_handler,
  };

  ESP_ERROR_CHECK(gptimer_new_timer(&timer_config, &timer_1));
  ESP_ERROR_CHECK(gptimer_register_event_callbacks(timer_1, &cbs, (void*)8));
  ESP_ERROR_CHECK(gptimer_enable(timer_1));

  ESP_ERROR_CHECK(gptimer_new_timer(&timer_config, &timer_2));
  ESP_ERROR_CHECK(gptimer_register_event_callbacks(timer_2, &cbs, (void*)9));
  ESP_ERROR_CHECK(gptimer_enable(timer_2));

  //Setup Alarms
  timer_1_alarm_config ={
    .alarm_count = 10000,
    .reload_count = 0,
  };
  timer_1_alarm_config.flags.auto_reload_on_alarm = false;
  timer_2_alarm_config ={
    .alarm_count = 450000,
    .reload_count = 0,
  };
  timer_2_alarm_config.flags.auto_reload_on_alarm = false;
  ESP_ERROR_CHECK(gptimer_set_alarm_action(timer_1, &timer_1_alarm_config));
  ESP_ERROR_CHECK(gptimer_set_alarm_action(timer_2, &timer_2_alarm_config));

Both timers work as intended, but timer_1spits out this error over uart
E (4167944) gptimer: gptimer_start(370): timer is not enabled yet

I'm not sure what the problem is.
I tried initialising them the other way round. No change.
I tried initialising them at different points in the code. No change.