Esp32-S3 : Problem with ADC in One Shot Mode

ThomasESP32
Posts: 229
Joined: Thu Jul 14, 2022 5:15 am

Esp32-S3 : Problem with ADC in One Shot Mode

Postby ThomasESP32 » Tue May 23, 2023 1:48 pm

Good afternoon,

I am trying to use the ADC in one shot mode on ESP32-S3.
I have use the One_Shot Read example and I use calibration in Curve Fitting Mode.
(It seems that it is the only mode available on the Esp32-S3 - I use the Esp32-S3-DevKitC-1 board).

My problem is that even if I calibrate the ADC, it seems that the Read value cannot go further than 3137mV.

Do you think it is possible to go further than this value ? Maybe something like 3,3V max ??

Thank you for your help,
Best regards,

Thomas TRUIHE

xien551
Posts: 69
Joined: Wed Feb 02, 2022 4:04 am

Re: Esp32-S3 : Problem with ADC in One Shot Mode

Postby xien551 » Wed May 24, 2023 8:22 am

I think it is difficult.

But you can use a voltage divider made up of two resistors, about 100K. If the transducer has a large value of output impedance, the voltage divided resistor should be larger.

Who is online

Users browsing this forum: Bing [Bot] and 303 guests