Hello everyone.
I am using ESP32-C3-MINI-1, on my own project.
By default, the D+ and D- (USB) lines are used internally for programming/debugging.
Can I use the USB lines for my project, without permanently programming the bits inside the "fuse" register.
I don't want to permanently disable JTAG/USB debugging while I'm in product development.
If possible, how to do it ?
Tnx
ESP32-C3 JTAG/USB
-
- Posts: 9709
- Joined: Thu Nov 26, 2015 4:08 am
Re: ESP32-C3 JTAG/USB
Yes, you can simply reconfigure those GPIOs in your program. Note that when you do that,the USB-serial-JTAG doesn't work anymore until you reset the ESP32C3.
Who is online
Users browsing this forum: No registered users and 179 guests