uart: uart_param_config(748): Invalid src_clk
Posted: Mon Mar 13, 2023 1:41 am
Hello
My code was working well. But I could see this error after changing my board and IDF version as 5.0 from 4.4
Is it hardware problem or I have to change pin or uart configuration in my code?
My code:
My code was working well. But I could see this error after changing my board and IDF version as 5.0 from 4.4
Is it hardware problem or I have to change pin or uart configuration in my code?
My code:
Code: Select all
#define LPC_TXD_PIN (GPIO_NUM_17)
#define LPC_RXD_PIN (GPIO_NUM_18)
#define LPC_UART_NUM UART_NUM_0
void lpc_uart_init(void) {
const uart_config_t uart_config = {
.baud_rate = 115200,
.data_bits = UART_DATA_8_BITS,
.parity = UART_PARITY_DISABLE,
.stop_bits = UART_STOP_BITS_1,
.flow_ctrl = UART_HW_FLOWCTRL_DISABLE
};
uart_driver_install(LPC_UART_NUM, RX_BUF_SIZE * 2, 0, 0, NULL, 0);
uart_param_config(LPC_UART_NUM, &uart_config);
uart_set_pin(LPC_UART_NUM, LPC_TXD_PIN, LPC_RXD_PIN, UART_PIN_NO_CHANGE, UART_PIN_NO_CHANGE);
}