ESP32-S3-DevKitC-1 : Use of Eclipse With ESP-IDF. How to program the module using the USB connector ?
Posted: Fri Mar 10, 2023 3:06 pm
Good afternoon,
I am using a ESP32S3-DevKitC-1 module with Eclipse and ESP-IDF.
At the moment, I can see the module appearing as COM port when I connect the board using the UART connector of the board.
So I use this connector to program the ESP32-WROOM1 using Eclipse.
I would like to use the USB connector instead but the DevKitC-1 does not appear as a COM port when I connect it on this connector.
Is it possible to use the USB connector to program the board ?
Could you please tell me how to do it ?
Best regards,
Thomas TRUILHE
I am using a ESP32S3-DevKitC-1 module with Eclipse and ESP-IDF.
At the moment, I can see the module appearing as COM port when I connect the board using the UART connector of the board.
So I use this connector to program the ESP32-WROOM1 using Eclipse.
I would like to use the USB connector instead but the DevKitC-1 does not appear as a COM port when I connect it on this connector.
Is it possible to use the USB connector to program the board ?
Could you please tell me how to do it ?
Best regards,
Thomas TRUILHE