Flash Encryption VSCode esp-idf
Posted: Thu May 26, 2022 2:32 pm
So I am trying to use the flash encryption feature so that my firmware can not be extracted from the device.
I am using the espressif extension built in vs code. Where enabled the flash encryption on boot. And selected Release mode. See image below
.
However after I flash the device I have the following error in the terminal(cant read the flash):
Not sure what I am doing wrong. Please any assistance will be highly appreciated.
I am using the espressif extension built in vs code. Where enabled the flash encryption on boot. And selected Release mode. See image below
- flash encryption.png (24.4 KiB) Viewed 1270 times
However after I flash the device I have the following error in the terminal(cant read the flash):
- error.png (18.99 KiB) Viewed 1270 times