Low freq (below 1Hz) PWM / Timers
Posted: Sat Sep 21, 2019 7:12 am
I am looking for an example of low frequency (below 1Hz) PWM.
Frequencies below 1Hz are impossible using LEDC driver and it's code (/components/driver/ledc.c) is rather ununderstandable for me.
Technical Reference shows general diagram (page 379) but I do not know exact way to set mentioned registers
My little attempt:
Frequencies below 1Hz are impossible using LEDC driver and it's code (/components/driver/ledc.c) is rather ununderstandable for me.
Technical Reference shows general diagram (page 379) but I do not know exact way to set mentioned registers
My little attempt:
Code: Select all
// Enable PWM peripheral
DPORT_SET_PERI_REG_MASK(DPORT_PERIP_CLK_EN_REG, DPORT_LEDC_CLK_EN);
DPORT_CLEAR_PERI_REG_MASK(DPORT_PERIP_RST_EN_REG, DPORT_LEDC_RST);
// LEDC_TICK_SEL_HSTIMER0: 0:ref_tick, 1:apb_clk
// REF_CLK_FREQ=1Mhz(20bit). Division 18bit.
uint16_t division = (REF_CLK_FREQ >> 4); // Period 16s
WRITE_PERI_REG(LEDC_HSTIMER0_CONF_REG, LEDC_HSTIMER0_RST | (division<<LEDC_DIV_NUM_HSTIMER0_S) | (8<<LEDC_HSTIMER0_DUTY_RES_S));
WRITE_PERI_REG(LEDC_HSCH0_CONF0_REG, (1<<LEDC_IDLE_LV_HSCH0) | (1<<LEDC_SIG_OUT_EN_HSCH0));
WRITE_PERI_REG(LEDC_HSCH0_HPOINT_REG, 0);
WRITE_PERI_REG(LEDC_HSCH0_DUTY_REG, 0);
WRITE_PERI_REG(LEDC_HSCH0_CONF1_REG, (LEDC_DUTY_START_HSCH0));
PIN_FUNC_SELECT(GPIO_PIN_MUX_REG[PIN_NUM_PWM_OUTPUT], PIN_FUNC_GPIO);
gpio_set_direction(PIN_NUM_PWM_OUTPUT, GPIO_MODE_OUTPUT);
gpio_matrix_out(PIN_NUM_PWM_OUTPUT, LEDC_HS_SIG_OUT0_IDX, PWM_OUTPUT_INVERTED, 0);