ESP32 Forum

Posted: **Wed Aug 21, 2019 8:45 pm**

Hi All,

I am new to this environment ,but went through all the guides and reference about jtag dbugging wrover kit documents still i am stuck in middle,unable to debug any c CODE on eclipse with wrover kit.

trying from many days but not able to make it up can you guys help me in this issue..?

regards
Atul

Posted: **Thu Aug 22, 2019 6:26 am**

Just to rule out the obvious. Are you able to debug without using eclipse (i.e. running OpenOCD and GDB)?

Posted: **Thu Aug 22, 2019 8:03 pm**

ESP_Dazz wrote: ↑
Thu Aug 22, 2019 6:26 am
Just to rule out the obvious. Are you able to debug without using eclipse (i.e. running OpenOCD and GDB)?

Hi Dazz,

I am not geting that only its working or no.

openocd is detecting the remote target i think when i try to launch the debug it gives some error i am attaching the
screenshot of both openocd and gdb command line responces.

anything else you need let me know.

Regards
Atul

ESP32 Forum

Can anyone guide me for debugging code on eclipse using WROVER kit

Can anyone guide me for debugging code on eclipse using WROVER kit

Re: Can anyone guide me for debugging code on eclipse using WROVER kit

Re: Can anyone guide me for debugging code on eclipse using WROVER kit