Suppress Boot messages

[IgnacioCipo]

Hi! I´m getting the same error: rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT).
And this reboots my esp32. Could you tell me the cause of this message please?
Thanks!

[ESP_Sprite]

IgnacioCipo: That tends to mean power was lost and regained, or the EN pin was pulled high. If you have more questions, suggest to start your own topic for this.

[doncogit]

Using arduino IDE for my code.
iam trying this on a esp32s3 devkit. connected GPIO15 to GND. Tried with and without 10k resistor but i still get this on boot:

ESP-ROM:esp32s3-20210327<\r>
<\n>Build:Mar 27 2021<\r>
<\n>rst:0x1 (POWERON),boot:0x8 (SPI_FAST_FLASH_BOOT)<\r>
<\n>SPIWP:0xee<\r>
<\n>mode:DIO, clock div:1<\r>
<\n>load:0x3fce3808,len:0x44c<\r>
<\n>load:0x403c9700,len:0xbe4<\r>
<\n>load:0x403cc700,len:0x2a68<\r>
<\n>entry 0x403c98d4<\r>

There is no change in behaviour.
Does anyone have an idea?

kind regards

[ESP_Sprite]

That is a different chip; please start your own topic for this. (And read the ESP32-S3 TRM/datasheet - on that chip you need to burn an efuse to suppress boot messages.)

Locking this topic.