Reset to Initial state after Commissioning over BLE

[ytwytw]

Hello,

After I built "CHIP ESP32 All Clusters Example" and flashed it to an ESP32, I can see it's doing BLE advertisement.
I then run the Python Controller example (https://github.com/project-chip/connect ... g-over-ble) to pass wifi credentials to esp32. It worked.

However, whenever I reboot esp32, it doesn't seem to do BLE advertisement again.
What's an easy way to reset it so I can test commissioning over ble again?
Is it possible to accomplish that using "idf.py" or other command-line tools?

Thank you.

[chegewara]

Code: Select all

idf.py erase-flash