Minimal Hardware for bare ESP-WROOM-32
Posted: Fri Jun 08, 2018 9:51 pm
I would like to know if I can upload code in my bare ESP-WROOM-32 with a minimal hardware.
I'm using an FTDI with TX, RX, and GND pins (not RTS and CTS pins), I found documentation about this, indeed, that's possible, I had success, but you have to add two buttons for pointing the sequence has started.
My goal isn't to add these two buttons, I need to reduce my hardware, only with the FTDI. Is it possible to do this by modifying configuration files?
Thanks.
I'm using an FTDI with TX, RX, and GND pins (not RTS and CTS pins), I found documentation about this, indeed, that's possible, I had success, but you have to add two buttons for pointing the sequence has started.
My goal isn't to add these two buttons, I need to reduce my hardware, only with the FTDI. Is it possible to do this by modifying configuration files?
Thanks.