ESP32 Forum

Hi all,
I'm knew here and kinda new on ESP IoT stuff. I built a pipeline with an esp8266 wired to a reed switch that send an http request to the esp32 cyd in case the door opens.
Now I'm wondering, is it possible to directly connect the esp32 cyd to a reed switch?
Thanks a lot for any help

bonbock wrote: ↑

Fri Sep 27, 2024 6:28 am

Now I'm wondering, is it possible to directly connect the esp32 cyd to a reed switch?

Should be possible. There seem to be a few GPIO pins available: https://randomnerdtutorials.com/esp32-c ... lable-pins

Thanks a lot. Yesterday I got my ESP32 cyd and tested on CN1 using GPIO22 and GND. Working fine.
Is it ok to use just ground and a pin with a reed switch or I will have problems?
Thanks again

No problems there. Set the pin as input, enable the internal pull up resistor, and you're good.

Perfect, thanks a lot