ESP32-C6 not recognised
Posted: Fri May 17, 2024 11:00 am
I'm having an issue with my ESP32-C6 module when connecting it to my Windows 10 PC. The device is not being recognized, and I keep getting the error message "USB Device Not Recognized." Here's a summary of my setup and the steps I've taken so far:
Setup:
ESP32-C6 module
Windows 10 Pro (version 1809)
Using a USB cable that supports data transfer
ESP-IDF 5.1.1 with Visual Studio Code (version 17.7.6)
Issue:
When I connect the ESP32-C6 to my PC using the USB port, it doesn't get recognized. Instead, I see an error in the Device Manager: "Unknown USB Device (Device Descriptor Request Failed)."
Steps Taken:
Tried different USB cables (all supporting data transfer).
Connected to different USB ports on my PC.
Restarted the PC and reconnected the device.
Tried connecting the device to another PC, but faced the same issue.
Checked the Device Manager for any warning symbols or errors under "Universal Serial Bus controllers."
Despite these steps, the issue persists. I also reviewed the official documentation for the ESP32-C6 and related forums, but couldn't find a solution.
Is this a known issue with the ESP32-C6, and are there any specific troubleshooting steps I might have missed?
Could this be a hardware fault with the ESP32-C6 itself?
Are there any specific driver versions or settings I should try to ensure proper recognition of the device?
Any help or suggestions would be greatly appreciated. Thanks in advance for your assistance!
Best regards,
Setup:
ESP32-C6 module
Windows 10 Pro (version 1809)
Using a USB cable that supports data transfer
ESP-IDF 5.1.1 with Visual Studio Code (version 17.7.6)
Issue:
When I connect the ESP32-C6 to my PC using the USB port, it doesn't get recognized. Instead, I see an error in the Device Manager: "Unknown USB Device (Device Descriptor Request Failed)."
Steps Taken:
Tried different USB cables (all supporting data transfer).
Connected to different USB ports on my PC.
Restarted the PC and reconnected the device.
Tried connecting the device to another PC, but faced the same issue.
Checked the Device Manager for any warning symbols or errors under "Universal Serial Bus controllers."
Despite these steps, the issue persists. I also reviewed the official documentation for the ESP32-C6 and related forums, but couldn't find a solution.
Is this a known issue with the ESP32-C6, and are there any specific troubleshooting steps I might have missed?
Could this be a hardware fault with the ESP32-C6 itself?
Are there any specific driver versions or settings I should try to ensure proper recognition of the device?
Any help or suggestions would be greatly appreciated. Thanks in advance for your assistance!
Best regards,