VSCODE settings for ESP32-S3
Posted: Tue Sep 12, 2023 3:27 am
Hi,
This is related to my last post but now I have changed the wiring connection.
I have ESP32-S3-DEVKIT and have connected +5, GND, D- and D+ to USB port on my Windows PC.
The kit shows up under "Universal Serial Bus Device" in Windows device list as "Espressif CDC Device"
However, I cannot get my code to download to flash.
I selected the S3 chip and then "built-in USB JTAG"
After build and compile I get prompted to start OCD. When I select YES I get error "could not find or [Open OCD]
This is related to my last post but now I have changed the wiring connection.
I have ESP32-S3-DEVKIT and have connected +5, GND, D- and D+ to USB port on my Windows PC.
The kit shows up under "Universal Serial Bus Device" in Windows device list as "Espressif CDC Device"
However, I cannot get my code to download to flash.
I selected the S3 chip and then "built-in USB JTAG"
After build and compile I get prompted to start OCD. When I select YES I get error "could not find or [Open OCD]