Touch 2 not working on DevKit, prints zero
Posted: Sun Aug 21, 2022 6:44 pm
Hi,
I'm using a Node MCU DevKit and want to use 9 touch sensors. However, TOUCH2 (T2) does not work. I realize that T1 is not exposed on this board, but according to the datasheets (for example: https://joy-it.net/files/files/Produkte ... -06-29.pdf) T2 should work fine...?
Here's a typical printout of running one of the touch examples, note how T2 always reads 0:
Note that I've found other posts across the net where people mention the same problem, but no solution...
Do I need to configure something in order for T2 to work?
Thankful for any help...
I'm using a Node MCU DevKit and want to use 9 touch sensors. However, TOUCH2 (T2) does not work. I realize that T1 is not exposed on this board, but according to the datasheets (for example: https://joy-it.net/files/files/Produkte ... -06-29.pdf) T2 should work fine...?
Here's a typical printout of running one of the touch examples, note how T2 always reads 0:
- T2.png (119.96 KiB) Viewed 1351 times
Do I need to configure something in order for T2 to work?
Thankful for any help...