ESP32 Forum

Code: Select all

    esp_vfs_fat_sdmmc_mount_config_t mount_config;
    mount_config.max_files = 5;
    mount_config.format_if_mount_failed = true;
    mount_config.allocation_unit_size = 2 * 1024;

    sdmmc_host_t host = SDMMC_HOST_DEFAULT();
    host.slot = SDMMC_HOST_SLOT_1;
    host.max_freq_khz = SDMMC_FREQ_DEFAULT;
    // host.max_freq_khz = SDMMC_FREQ_PROBING;

    // This initializes the slot without card detect (CD) and write protect (WP) signals.
    // Modify slot_config.gpio_cd and slot_config.gpio_wp if your board has these signals.
    sdmmc_slot_config_t slot_config = SDMMC_SLOT_CONFIG_DEFAULT();

    // To use 1-line SD mode, change this to 1:
    slot_config.width = 4;

    // Enable internal pullups on enabled pins. The internal pullups
    // are insufficient however, please make sure 10k external pullups are
    // connected on the bus. This is for debug / example purpose only.
    // slot_config.flags |= SDMMC_SLOT_FLAG_INTERNAL_PULLUP;

    // Disabling all pull down on GPIO pins used for SDIO slot 1 : 2, 4, 12, 13, 14, 15
    gpio_pulldown_dis(GPIO_NUM_2);
    gpio_pulldown_dis(GPIO_NUM_4);
    gpio_pulldown_dis(GPIO_NUM_12);
    gpio_pulldown_dis(GPIO_NUM_13);
    gpio_pulldown_dis(GPIO_NUM_14);
    gpio_pulldown_dis(GPIO_NUM_15);

    esp_vfs_fat_sdmmc_mount(mountPoint.data(), &host, &slot_config, &mount_config, &card);

Code: Select all

    host.flags = SDMMC_HOST_FLAG_1BIT;