WROVER-E flash programming before sending to the factory

thierry37_2
Posts: 11
Joined: Tue Jul 23, 2019 12:52 pm

WROVER-E flash programming before sending to the factory

Postby thierry37_2 » Tue Jun 14, 2022 5:59 pm

Dear Espressif Team

I am designing a custom board using a WROVER-E module, and I need to produce 200 boards. Due du component shortage in general, I have already purchased 200 WROVER-Modules.

I would like to be able to flash them by myself before sending them to the factory, so that they can easily test the boards without need to flash the firmware.

Is there a tool that I could use for flashing the WROVER-E modules before sending them at factory ?

Many thanks
Thierry

thierry37_2
Posts: 11
Joined: Tue Jul 23, 2019 12:52 pm

Re: WROVER-E flash programming before sending to the factory

Postby thierry37_2 » Tue Jun 14, 2022 7:10 pm

I think that I have found what I need : ESP32-DEVKITS-R which is availabe at digikey.
Best Regards
Thierry

Who is online

Users browsing this forum: No registered users and 96 guests