Strapping pins for programming on Rover modules

djoshi
Posts: 53
Joined: Wed Jan 12, 2022 9:59 pm

Strapping pins for programming on Rover modules

Postby djoshi » Tue Mar 15, 2022 4:44 pm

Hi All

I am trying to understand the Strapping pins setup.

I have added P2 and P3, which are pin headers that force the IO0 and IO2 to GND.

IO0 is also connected to I2S_SCK
IO2 is also connected to UART1 TX

So am I correct in understanding that on power-up,IO0 and IO2 are pulled down to GND it will force the module to go into download mode. In Download mode, TX and RX UART 0 will be used. Once the programming is completed, I can remove the connection to GND for IO0 and IO2 and it will boot my application as normal?

Is this a correct understanding?
PCBStrap.png
PCBStrap.png (66.38 KiB) Viewed 1299 times

Who is online

Users browsing this forum: Baidu [Spider] and 69 guests