ESP32 confusing interrupt behavior

[Bilal_azhar]

Hi! The hardware I am using is an esp32-cam AI thinker board and a SR602 PIR motion sensorhttps://www.sinoning.com/hc-sr602-datasheet/. The output pin is connected to the ground with a 10K resistor

My objective is to wake up the esp32 from deep sleep whenever the sensor output voltage drops from 3.3v to 0. I have tested my setup the sensor works properly it outputs 3,3v across the 10k resistor when I move my hand over it and the esp32 wake-ups when I connect GPIO 13 to the ground (esp32 wakes up).

The problem I am facing is that when I connect my sensor output to GPIO 13 things don't make sense, from what I understand the device should only wake up when the sensor changes voltage from 3,3 to GND. This doesn't seem to be the case the esp32 keeps waking up randomly in 1-2 seconds after the deep_sleep start function is called. I thought maybe something is wrong with the sensor so I connected the GPIO 13 straight to GND and that shouldn't trigger the wake interrupt right? But I am seeing the same behaviour. Can anyone help figure out what's wrong?

Code: [Select all] [Expand/Collapse]

1. #define MOTION_WAKEUP_PIN 13
2.  
3. void gpio_init(gpio_int_type_t INTR_MODE, gpio_mode_t PIN_MODE , gpio_pull_mode_t UP_MODE , gpio_pull_mode_t DOWN_MODE, u_int32_t PIN)
4. {
5.     gpio_config_t io_config;
6.     io_config.intr_type = INTR_MODE;
7.     io_config.mode = PIN_MODE;
8.     io_config.pull_up_en = UP_MODE;
9.     io_config.pull_down_en = DOWN_MODE;
10.     io_config.pin_bit_mask = 1ULL << PIN;
11.     gpio_config(&io_config);
12. }
13.  
14. void app_main(void)
15. {
16.     //Initialize NVS
17.     esp_err_t ret = nvs_flash_init();
18.     if (ret == ESP_ERR_NVS_NO_FREE_PAGES || ret == ESP_ERR_NVS_NEW_VERSION_FOUND) {
19.       ESP_ERROR_CHECK(nvs_flash_erase());
20.       ret = nvs_flash_init();
21.     }
22.     ESP_ERROR_CHECK(ret);
23.  
24.     ESP_LOGI(wifi_TAG, "ESP_WIFI_MODE_STA");
25.     wifi_init_sta();
26.  
27.     gpio_init(GPIO_INTR_NEGEDGE,GPIO_MODE_INPUT,GPIO_PULLUP_ENABLE,GPIO_PULLDOWN_DISABLE,MOTION_WAKEUP_PIN);
28.  
29.     while(1){
30.  
31.         vTaskDelay(5000 / portTICK_RATE_MS);
32.         esp_deep_sleep_start();
33.  
34.     }
35.  
36. }

GeSHi © Codebox Plus Extension

[ESP_Sprite]

Hard to say. Do you have an oscilloscope so you can look at the signals the PIR sensor outputs? Perhaps it somehow has spikes that confuse the wakeup mechanism.

[MicroController]

You don't seem to have set up/enabled any wake-up source.