Anyone?

[/quote]
use the S2 TRM for the S2-Mini instead the C3-TRM which was linked in the post
[/quote]

I noticed that, thanks!!

Hi everyone,

I want to intergrate the ESP32-S2-MINI module into my design. Can I use the JTAG interface for debugging and flashing as well? If JTAG serves both features do I need to include USB connector and USB to UART Bridge?

Thanks

Thank you ESP_Sprite!!

Anyone?

Hi everyone, I want to intergrate the ESP32-S2-MINI-1 module to my design. My design requires 18 external interrupts and looking the datasheet of the ESP32-S2-MINI-1 module I see that there are available 25 gpios. However what it is not mentioned is what gpios can be used as external interrrupts... ...

Hi everyone,

Does anyone knows any MQTT Client library that publishes messages with QOS 2? It is really important to me as the existing I am using sends with QOS 0 any many times messages does not reash their destination.

Thanks in advance.

Hi everyone, I compile and upload the following sketch on esp32 devkic void setup() { Serial.begin(9600); Serial.println("Hi"); count(); } void count(){ for (int i=0;i<5;i++){ Serial.println(i); } } void loop() { } The problem is that the serial monitor shows nothing.. When I upload the same sketch ...

I started receive some measurements but are quite inaccurate. I compared the voltage readings of esp32 with that of my multi meter and there is high deviation. For example with the multimeter I read 0.14V while with esp32 0.01V. I suppose that this is not some issue of my code. The ADC reading is qu...

Dear all,

I've got an ESP32 Devkitc and I need to control a 5V relay through a GPIO pin.

I will supply 5V (using a battery and dc/dc converter) into the 5v pin of ESP32. The GPIO outputs is going to be 5V OR 3.3V?

In general is it possible to control a 5V relay with ESP32?

Thanks is advance