No activity in Serial port
I tested configuring the sleep mode just 3 min, power OFF on sleep time and power ON, wait 3 minute, but not restart, can be recovered just if I do a manual restart or load again the configuration.

can someone with ESP32 can tried this test?

Hi Thanks for you answer And yes i'm using a big capacitor to avoid "Brownout detector", I got an GSM module connected with ESP32 I'm using two batteries 18650 2200ma, with a DC DC converter to increase the voltage to 5.2V connected to ESP32 VCC pin ESP32 board used are MH ET LIVE ESP32 minikit ardu...

Thank you very much
I will tried up as soon as possible I have one humidity sensor with RS485 and im not able to run it up

Hi I'm working in a project that send data to cloud each hour with ESP32. I'm using "esp_deep_sleep_start();" If I power down "With a physical switch", the module during deep sleep mode. when I power up the module did not startup, just is possible to start again with a manual reset. Do you know how ...

Hi, the solution is simple add a I2C extender chip

Problem solved

Hi thanks, yes was not ESP problem, was low power input to the GSM module.

Problem solved

Hi
always is necessary MAX-3485 as interface or I can connect it directly to ESP32 pin?

Thanks....

Thank to much
I will tried it.

Hi This arduino lib are made for arduino HW that has by default A4,A5 ping. You may to change the .cpp lib add the esp32 ping like : Wire.begin(21,22); // Initialize I2C the pings to add, is located here // INITIALIZATION // This function initializes the MMA8452Q. It sets up the scale (either 2, 4, ...

Hi, good work
I want to connect a sensor that use RS485, can you share your code?

Thanks for sharing your work.