Hello, Actually i made one project before 1 year, it was working fine. But now we have to make some modification.So,i have tried to recompile that project. But i am getting some error like: "/bin/sh: python: command not found make[1]: *** [/home/kishan/esp32-at/esp-idf/components/esptool_py/Makefile...

Hello, Actually, i am using esp32 dev-kit. I have flashed firmware of AT-command to it. I simply connect to WiFi network by using "AT+CWJAP" command. It connect successfully. Now, i continuosly check of available AP near by it(Use AT+CWLAP), it make hang device after some time. I have also tried to ...

Hello,
I have used 2 uarts out of 3 and now there is also need to use 3rd uart.
I had seen in document that there are some restriction to use uart1 pin.

So, if i will try to use that pin. Is there any affect on internal process?

Thanks and Regards,
Kishan Patel.

Hello,
Thanks for reply. Is there any example available for log file?

Regards,
Kishan Patel.

Hello Fly135,
Actually i want to generate file on board means esp32. After some time which can be accessible.
Regards,
Kishan Patel.

Hello,
We can see all debug print on monitor screen by using "make monitor" command. Now i want to save all that logs in one file. Is it possible means how can generate log file to debug purpose?

Thanks and Regards,
Kishan Patel.

Thanks,
We have using CPH6341 MOSFET. We have tried as you told(remove MOSFET circuit) then check the process.But our TLV chip has blown-out.

Regards,
Kishan Patel.

Hello,
Yeah sure.I have attached schematic image of power supply.
Thanks.

Hello,
I have used MOSFET.When i remove 12 volt,device has hangup.If i again give 12 volt when device has working on backup battery,there is no issue.But when remove 12 volt,sometimes Brownout reset occur and sometimes device has hang.

Thanks.

Hello, Actually,i am using 2 type power sources with esp-wrrom32 module. One is 12 volt dc supply and another is 3.7 volt(back_up battery purpose). Problem which i have facing is that when i try to switch power supply,sometimes device will detect Brownout and reset,then start application as it is.Bu...