More on this: I started adding debugging information within the block and my boolean value (also tried to change its type to basic bool) prints as ... 47! Then, when negating the boolean, it converts to 46, then back to 47, etc. so it seems using RTC_NOINIT_ATTR seemingly changes its data type as we...

Hello, I'm programming a C6 in Arduino mode with pioarduino. My code has a boolean value that has to swap back-n-forth to properly operate an electrical motor (one time in one direction, one time in the other, etc.) Yet, from time to time, I need to soft reboot my device and when doing so, it will a...

Thanks! The 8266 internal clock was actually pretty good based on my measurements (about 265ms per day, so manageable), but the deep sleep makes it hard to connect the dot, as discussed, as I don't have a way to evaluate the time spent probably between going to sleep and recovery (anything that "mil...

In order for the device to wake itself, the RST pin must be connected to the D0/GPIO16 pin. However, that connection must be disabled when uploading new code AFAICT. Did you do so? Once it recovers from deep sleep - unlike for light sleep - it will go through a full setup->loop phase much like a ful...

TLDR; When going into deep sleep, I need to "recompute" the actual time, but I cannot seem to find a way to do so semi-precisely. Context: I am managing an old (remote) clock through electrical signals, so need to send an impulse every minute. I first obtain my time with wifi/NTP, then, to reduce po...