Many apologies for my delay in replying. Read GPIO_STATUS_REG (0×0044) to check if GPIO interrupt is generated. I tried this, it had bit 22 set as expected. Set INTMTX_CORE0_CPU_INTR_FROM_CPU_0_MAP_REG (0×001C) to 1, then set INTPRI_CPU_INTR_FROM_CPU_0_REG (0×0090) to 1, to check if CPU interrupt co...

In TRM 1.6.3.2(1), it says "save the state of MIE and clear MIE to 0". I had assumed that it meant the MIE CSR, but maybe it meant the MIE bit in MSTATUS? I’ve tried this, but it made no difference. I did notice that when I began the procedure, MSTATUS had both MIE and MPIE set, which is I think con...

Apologies for late reply: I was on leave. You're quite right about my referencing GPIO_1 at the end; I meant GPIO_3. I will point you to my code, but it's in Ada, so may not help much. Setting up interrupts: https://github.com/simonjwright/FreeRTOS-Ada/blob/master/esp32h2/adainclude/s-iemiha.adb (no...

I'm working on a bare-metal code for the ESP32-H2, and I can't get an interrupt from a GPIO pin. If this is the wrong place to raise this, I'm sorry - where should I raise it? Using the Technical Reference Manual Pre-release v0.4. (0.5 doesn't have any updates in sections 1, 6, 9) Enabling the inter...