Hey guys, I'm back again with another problem. =/ rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) ets Jun 8 2016 00:22:57 rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0x00 clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clo...

Well, I got it to work already. Turns out it was my USB setting on VirtualBox. I was using USB 2.0 (EHCI) controller. Apparently, it only works with USB 3.0 (xHCI) controller. Hmmm... Thanks a lot for your help nonetheless! Do you mind explaining why I should not connect the USB UART's 3.3V to ESP32...

Thank you so much for the prompt reply. http://static.sparkfun.com/assets/home_page_posts/2/0/1/7/example_hookup_bb-2.png I refered to this hookup guide except that the GPIO0 were connected directly to 3.3V or GND (whenever necessary) instead of using a DIP switch as shown in the picture. I tried is...

Sorry for my lack of information. I'm using ESP32-Wroom module. I soldered jumper wires directly onto the module and plug the TX and RX jumpers into a FTDI 232H module which i used to flash the ESP32. I am using a Linux Ubuntu 16.04.1 LTS running on VirtualBox using Windows 10 Education. I was able ...

i'm using 115200.

Hey guys, I am having trouble to flash the ESP32 after updating to the latest esp-idf. After i used "make flash", these 2 errors occur pretty often: [b]A fatal error occurred: Failed to write to target RAM (result was 0x1, 0x7, 0x0, 0x0)[/b] ~/esp3/esp-idf/components/esptool_py/Makefile.projbuild:47...

sweet! thank you so much!

May I know if the bug has been fixed?? I don't see it in the commits.

Hey guys, I have been playing with ESP32 module for the past few days. I have gotten around activating UART1 using IO 9 (RX) and IO 10 (TX). The following code is my UART setting: int uart_num = 1; //uart port number uart_config_t uart_config = { .baud_rate = 19200, //baudrate .data_bits = UART_DATA...