Thank you very much for answering my question .. it helped me solve the problem. I would like to point out that the documentation you sent me to, is confusing to anyone but an expert in the field. The following two sentences in the wifi/BT section appear to conflict. -In Deep-sleep and Light-sleep m...

Thanks for the suggestion EDsteve. Problem is I can get low deep sleep current simply by uploading a short sketch with just a deep sleep command ... only about 0.2 ma. That would seem to indicate that the TTGO development board is smart enough to turn off the UART and any other peripherals that use ...

I have a TTGO T-Display board configured as a internet radio. If I upload a simple sketch which does nothing for 10 seconds and then goes to sleep for 10 seconds, the current draw is 42 ma while idleing and 0.2 ma when in deep sleep. So far so good. But if I upload the radio sketch it draws 130 ma w...

I am a relatively new esp32 + arduino IDE programmer trying to hold a pin low during sleep. The problem is that all the documentation refers to the RTC pins by two different designations. i.e. GPIO pin 14 on all diagrams is also referred to as RTC_GPIO16. When using that pin as an RTC pin do I refer...

I have been trying for quite a while to interface a VS1053 mp3 decoder board with a TTGO T-Display board (ESP32 development board with a built in TFT display). Although I have seen reports of successfully interfacing with an SD card board with the TTGO, nowhere can I find anyone who has done it with...

I have built a working internet radio using another display ESP32 display board and a VS1053 decoder board. Now I would like to substitute the TTGo T-Display board into that radio. The problem is with the SPI connections between the TTGO and the VS1053 which I am having trouble under standing. Below...