Captura.JPG 13:32:53.713 -> rst:0x3 (SW_RESET),boot:0x12 (SPI_FAST_FLASH_BOOT) 13:32:53.713 -> configsip: 0, SPIWP:0xee 13:32:53.713 -> clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 13:32:53.713 -> mode:DIO, clock div:1 13:32:53.713 -> load:0x3fff0018,len:4 13:32:53.713 ->...

Hi everyone! I have developed a custom board with the ESP32-D0WD-V3.. I copy exactly the design from the wrover module... But I just use a 16MB flash... I can program the system perfectly with the Arduino IDE ... But when I open the serial monitor it looks like an endless reset loop.... I can not fi...

Hi felmune. Thanks for your response. Normally are IoT comertial devices use BLE to pass the credentials to the device? There is not an easier way ass a AP button in the router or something like that ? I have never use a IoT device from the market.. so i dont know the stadard used here..

Thanks..

Hi all. I am using the esp32s2 device. I have programed a staion with some sensors that connects to wifi and sends some data to my server. I guess this is a typical question but i didnt find a clear answer: :?: :?: How can i introduce the wifi pass and user with out declaring them in the code ? I me...

Thank you so much for your answer. This is still a challenge. If i am connected to a network with one pass and one usr. I can use those functions perfectly.. but if i want to change to another network (changing the usr and pass.. ) and i use those functions the system reboots...

Thanks a lot for your response.

I am using exatly the same coda as in the https request idf example... the rebooting is normal there ?

Thank you so much for your response. I use exactly the same functions as in wifi station example idf. I did this: esp_wifi_stop(); wifi_init_sta(); esp_wifi_start(); But the system reboots with the following info: I (32410) wifi:state: run -> init (0) I (32410) wifi:pm stop, total sleep time: 174941...

I am using the simplest wifi station example... i am passing the WIFI usr and pass through uart to the esp32s2. the first time i pass those values to the board, everything is ok. But now i want to pass again those values while the board is connected to wifi.. so i guess i need to disconnect the boar...

I am trying to acces to some server, to get json responses trough https. I get the responses perfectly the 90% of the time... but sometimes it launch this: I (11320) wifi station: Start https_request example I (11320) wifi station: https_request using crt bundle E (11330) esp-tls: couldn't get hostn...

Thanks all..

What I don't understand is that any other code is perfectly working in my custom board but the WiFi... If other codes are charged correctly I suppose that it is not a hardware problem right? .. not decoupling nor even reset or insufficient current from the usb right ?