Hi I am trying to implement a people counter-based of scans of mobile phones that have the Wi-Fi turned on Note: I want so say here that I want to know how many people has the Wi-Fi turned on, no the Access point Wi-Fi mode. I don´t want a trivial Wi-Fi Scan example I saw in Arduino IDE that there i...

Good morning. I am developing a tracker based on a ESP32. I need to reset a counter variable every time I receive a '1' logic in GPIO 27. I started using ext1 wake up (because I have different wake-up sources) However, my problem is that I don´t want to wake up the ESP32 every time I get a '1' on GP...

Good morning. My name is Jorge and I am a Firmware developer for Sayme Corp. I am programming an IoT Device based on an ESP32 WROOM 32D. The functions of the ESP32 are: 1) Use it as a microcontroller 2) Scan Wi-Fi networks. 3) Scan BLEs I am developing the application with PlatformIO. A month ago, E...

I just try to use: //GPIO_SEL_5 (Regulator TPS610986DSER, PWR_MODE) gpio_struct.pin_bit_mask = GPIO_SEL_5; gpio_struct.mode = GPIO_MODE_OUTPUT; gpio_struct.pull_up_en = GPIO_PULLUP_DISABLE; gpio_struct.pull_down_en = GPIO_PULLDOWN_ENABLE; gpio_struct.intr_type = GPIO_INTR_DISABLE; ESP_ERROR_CHECK(gp...

I am developing an application with an ESP32 as a microcontroller. I always use the same function to have the minimum power consumption (above 8 - 10 uA) and I have never had problems. But in this development, I use GPIO_NUM_5 to turn on/off a 3,3 Volts regulator. With a '0' the regulator is off and...

mikemoy wrote: ↑

Tue Mar 31, 2020 2:19 pm

There is an example in the examples folder for doing just that.

Can you give me the link to this example?

Thanks in advance

Good morning. I am developing an ESP32 code where I use UART communications. I want to know how can I wait until I have a delimiter on RX data or I wait X time, at the same time, int uart_read_bytes(uart_port_t uart_num, char* buf, uint32_t length, TickType_t ticks_to_wait) always wait the number of...

Good Afternoon, I am doing an application for ESP32 (32D). In order to avoid high power compsuptions I am using 2 functions with RTC I/O's. For example, with GPIO 0: rtc_gpio_init(GPIO_NUM_0); rtc_gpio_isolate(GPIO_NUM_0); As I told before, I am using this 2 functions with all RTC I/O's. The power c...