As an additional info: I've run the same test after installing the pre-requisites and the esp-idf dev stack on a ubuntu docker image. Got the same error message.

Hi Roland, Thx for the reply. Following your suggestion I've created a minimal key-value pair for nvs: filename: test.csv content: key,type,encoding,value default,namespace,, key1,data,u8,1 I converted it to binary first, using: nvs_partition_gen.py generate test.csv test.bin 0x80000. and then I run...

HI, I've run out of ideas on this one and now my project is stuck - really appreciate if someone can help on this one. When running parttool.py to upload a .bin nvs file I get "UnicodeDecodeError: 'ascii' codec can't decode byte 0xe5 in position 1: ordinal not in range(128)" I am using esp-idf versi...

Hi, I am looking for recommendations on libraries to connect to TTN using lora transceiver RF96. I've managed to connect successfully using SX1276 + ttn-esp32 library. Unfortunately the same library seems not to work when using RF96. (I've banged my head for 2 days without success). Which library ar...

I am experiencing a sleep time drift/error when using ULP wakeup under different temperatures. I am calling: ulp_set_wakeup_period(900000000) // 15 minutes Situation1: - ESP32 Wroom 32E runs on ~23 degrees Celsius, I see the wake up happening about 2 seconds earlier than the 15 minutes. For me this ...

I am a bit stuck on this one and would appreciate help or tips from the community here... I am using ESP-IDF and using a dev board from TTGO (with LORA). I've programmed the GPIO 25 to have a 100KHz PWM output with 50% duty cycle. Looking at the osciloscope I see a nice, well behaved pulse 0-3.3V, a...

Hi Experts, I cannot get this right, so thought about asking for help here... I have an ESP32 DOIT dev board with D32, D33 used in input mode as follows: On D32 I have a temp sensor (D18B20). On D33 I use a voltage divider (1MOhm, 1.32MOhm) to allow me to read the voltage on a source of ~5.6V. The f...